Electrician in Vancouver

Vancouver has some of the oldest housing in the region: the character homes of Kitsilano and Mount Pleasant, the bungalows across East Van, and the wave of laneway houses going in behind them. We work across all of it, from a knob-and-tube rewire in a 1920s house to an EV charger in a downtown parkade. Old wiring is a constant theme.

A lot of Vancouver's stock predates modern electrical loads. Character homes east and west of Main still run on 60- or 100-amp services and their original wiring, and the city's laneway-house boom has added a whole category of small new builds that need their own service and metering. Both are daily work for us, and heritage homes need a careful, code-first hand.

The common Vancouver jobs are panel and service upgrades on older homes, knob-and-tube and aluminum remediation, laneway-house wiring, and EV chargers in both houses and strata parkades. Renovations here almost always turn up something behind the walls, so we plan the circuits around what a house of that age is likely hiding.

Vancouver work lives and dies on what's behind the walls. A Kitsilano or Mount Pleasant house from the 1920s can hide knob-and-tube, cloth-wrapped conductors, buried junction boxes, and a fuse panel all in the same basement, and none of it shows until the drywall comes off. We plan rewires in stages where it makes sense, tackling the overloaded and buried circuits first, and we map what's there so a homeowner can make decisions instead of getting surprised. The laneway-house boom has added a steady stream of small new builds that each need their own service, metering, and sometimes a trench across the yard from the main house. Downtown and strata work is a different discipline again, where the question is where power comes from in a shared parkade and what the building's rules allow. The City of Vancouver runs its own electrical permitting and inspection, which we keep moving so heritage and character jobs pass cleanly the first time.

Electrical services in Vancouver

Everything we do for homes and businesses across Vancouver, from a single repair to a full renovation or new build:

• Panel & service upgrades in Vancouver — 100A to 200A upgrades, panel replacements, and service masts — permits and BC Hydro coordination handled.
• Home renovations & rewiring in Vancouver — Renovation wiring, full and partial rewires, custom home and new-build wiring, knob-and-tube and aluminum remediation, kitchens and basement suites.
• Lighting design & installation in Vancouver — Pot light and LED installation, under-cabinet and landscape lighting, retail display work, and custom fixtures across Metro Vancouver.
• EV charger installation in Vancouver — Level 2 home and strata charging, load calculations, and BC Hydro rebate paperwork.
• Commercial & tenant improvements in Vancouver — Retail fit-outs, offices, warehouses — from demising walls to occupancy, on the schedule your lease demands.
• Electrical repairs & troubleshooting in Vancouver — Dead circuits, warm outlets, tripping breakers, flickering lights — diagnosed and fixed, 24/7 for emergencies.

Not sure which one fits? Start with a call or a quote request and we'll point you to the right service.

Permits and inspections in Vancouver

Electrical permits in Vancouver are issued and inspected by the City of Vancouver, one of the few BC municipalities that runs its own electrical inspection rather than deferring to Technical Safety BC. That means the permit, the inspection, and the sign-off all happen at the municipal level, and we pull and close those permits as part of every job that needs one. Keeping that paperwork moving is part of the service, so a project doesn't stall waiting on an inspector.

When a job involves a service upgrade, we also coordinate the BC Hydro disconnect and reconnect, and for EV chargers we hand you the documentation your BC Hydro or CleanBC rebate application needs. Permitted, inspected work by a licensed contractor is what keeps a rebate from bouncing and an insurance file clean.

Working with Pro Volt in Vancouver

We're a licensed BC electrical contractor (#LEL0203630), fully insured, with the founder still on the tools rather than behind a desk. Vancouver is part of our regular route across Metro Vancouver and the Fraser Valley, so getting out to you isn't a special trip, and there's a 24/7 line for anything urgent — sparking, a burning smell, or no power. Every quote is a fixed written price after we've seen the work, not an estimate that creeps upward once the job starts, and every job that needs a permit gets one, pulled through the City of Vancouver and inspected. If you're weighing a panel upgrade against a charger, or a repair against a rewire, we'll tell you what the situation actually calls for instead of selling you the bigger job.

How a Vancouver job goes

It starts with an assessment — often photos for a simple job, a site visit for anything involving the panel, the service, or a run of any length. From there you get a fixed written quote. Once you approve it, we pull the permit through the City of Vancouver, book any BC Hydro work a service change needs, and schedule around your other trades if it's a renovation. On the day, the work is done to the current BC Electrical Code, tested, and left ready for inspection. We don't call a job finished until it has passed and, where a rebate is involved, until you have the paperwork in hand.